|
Co-sponsoring Organizations
Ongoing Project Activities
|
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| Sponsorship Key | ||
| Blue: Sustainment/Readiness Panel | ||
| Purple: REPTECH | ||
| Orange: CTMA | ||
| Red: JTEG | ||
| Tuesday, 16 April | ||
| 1:15 PM | Near Dry Machining of
Aluminum Alex Stoll (Ford Motor Co) |
|
| 1:35 PM | Laser Engineered Net
ShapingTM Dave Keicher (Optomec) Tom McDonald (Laserfare) |
|
| 1:55 PM | Next Generation
Inspection System Jeff Calkins (Manufacturing Resources Inc) |
|
| 2:15 PM | Blade Tip Repair (FY96
445) Rafael Reed (US Air Force) |
|
| 2:35 PM | Break | |
| 2:50 PM | Thermal Spray Booth
Equivalency Unit Walter Riggs (TubalCain) |
|
| 3:10 PM | Engine Rotary Life Extension Steve Schwenker (US Air Force) |
|
| 3:30 PM | Lighter Weight and
Improved Lifetime in Military Systems Mike Hill (Univ. of California - Davis) |
|
| 3:50 PM | Ultrasonic Consolidation for Metal
Part Fabrication Bob Badgett (Solidica) |
|
| Wednesday, 17 April | ||
| 8:10 AM | Surface Preparation
Improvement at MCB Albany Charlie Tricou (Penn State University) |
|
| 8:30 AM | Submarine Vertical
Launch System Laser Cladding Pat Bergan (NUWC, Keyport) |
|
| 8:50 AM | Evaluation and Repair
of Marine Corps Light Armored Vehicle LAV-25 Eric Whitney (Penn State University) |
|
| 9:10 AM | Retrograde Part Identification in
Harsh Environments Gary Burkart (NCMS) |
|
| 9:30 AM | Break | |
| 9:50 AM | Natural Gas Engine Drive Air Compressors Mike Lin (US Army) | |
| 10:10 AM | Large Caliber Cannon
Life Extension via Tantalum Sputtering MTO Upendra Patel (US Army TACOM-ARDEC) |
|
| 10:30 AM | Uniform Cannon
Reshaping Walter Roy (US Army) |
|
| 10:50 AM | Aircraft Carrier Catapult Trough
Covers Laser Cladding Paul Blomquist (Penn State University) |
|
| 11:10 AM | Q
Switched Laser Stripping Pat Bergan (NUWC, Keyport) |
|
| Points of Contact: | |||
| Symposium
Registration: Shirley Phillips 734-995-7986 phone 734-995-0380 fax |
NCMS
Executive Director, CTMA Programs: Chuck Ryan 734-995-4905 |
||
|
National Center
for Manufacturing Sciences |